According to my research there are "A" and "B" brackets for the Correct Track system, like part # RR23QX for the tandem setup. Since you could potentially use all "A" or all "B" brackets they give you enough for any given scenario. It can be a bit confusing but they tried to make sure you have everything you need to get your trailer aligned properly. view full answer...
The rear stabilizers for a trailer only hold a small portion of the weight of the trailer so stabilizers rated for 15,000lbs just for the rear would be major overkill for your 2012 Prime Time Manufacturing Sanibel fifth wheel.
The axles and tires hold the majority of the weight with the landing gears picking up the rest. The stabilizers are meant to reduce the sway you might experience when walking around inside of the trailer.
If you'd prefer a new system that would include the landing... view full answer...
Old Furrion cameras are not able to connect to their Vision S monitors so while I know it's not the news you'd like to hear, you would have to replace the system with the Furrion Vision S # FOS43TASF. view full answer...
To determine the slide topper size you need you'll measure from the outside edge of the flange to the outside edge of the other flange. It's then recommended to have at least 7" of clearance on each side to ensure the arms of the topper don't come into contact with anything else. If you don't have enough clearance you'll want to go down a size.
If the flange to flange measurement of your slide-out is 97.5" then you'll want the Solera RV Slide-Out Awning - 8'1" Wide - 48" Projection -... view full answer...
For the strongest rear electric stabilizer I recommend the Ultra-Fab Power Twin II Electric Stabilizer with Dual Motors # UF39-941705. This stabilizer has has 30" of lift and a combined weight capacity of 6,000lbs, when legs are extended to 30", to help maintain the stability of your 2012 Prime Time Sanibel 3500 Fifth Wheel Trailer.
The dual, 12V motors operate independently of one another for simple, effective leveling on uneven terrain. The Extra-large footplates help to minimize sinking... view full answer...
The HWT Aluminum Hi-Spec Series 6 Trailer Wheel # AM22652B is a lug-centric wheel, meaning it will secure to your hub by sliding onto the lugs so the fact it has a different bore diameter than your current rim is perfectly fine.
These 15" x 6" rims have a 6 on 5-1/2" bolt pattern, which is the same pattern your hub would need to have in order for this wheel to fit correctly; if you are unsure of your bolt pattern you can take a look at the help article I linked which explains how to determine... view full answer...
Front mounted bike racks for travel trailers have a very limited weight capacity so you wouldn't be able to load your e-bikes on the front. Instead you'll have to use a trailer hitch receiver mounted bike rack that is rated for use on travel trailers and has a high enough per bike capacity to handle the weight of your 53lb e-bikes.
For this I recommend the Lets Go Aero V-Lectric FAT PRO Bike Rack for 2 Electric Bikes # LGA77FR. This bike rack has a per bike weight capacity of 75lbs to... view full answer...
It looks like the 2015 Prime Time Sanibel 3901 likely has 8000-lbs axles but you will want to confirm this is the case; for those you'll want to use the Electric Trailer Brake Kit w/ Dust Shields - Self-Adjusting - 12-1/4" - Left/Right Hand - 8K # AKEBRK-8. These brakes are self adjusting so you won't need to do any adjustments after installation; our brake kits don't come with mounting hardware included so you'll also need the Brake Mounting Hardware # BRKH122508.
I've linked a review... view full answer...
There is a potential option to give your 5th wheel trailer the added 2 inches of lift you are looking for by using a lift kit:
- Correct Track Trailer Alignment and Lift Kit - Tandem Axle # RR23QX
I say "potential" because there are a couple of things you need to check to ensure the # RR23QX will work for your Primetime Crusader. This kit requires at least 2-5/8" from the top of the hanger to its mounting hole, and the hanger needs to be 3" wide x 3-3/4" tall, or 3" wide x 5" tall. Those... view full answer...
The Lippert High-Speed Power Stabilizer Jack # LC298707 would be a great replacement option for your Lippert 198641 stabilizer jack. The motor # LC352338 for the # LC298707 hasn't been tested with the 198641 so it's not confirmed to fit. view full answer...
If you're replacing just the rooftop unit of your Dometic system with the Advent Air # ACM135 then it's a super easy swap out. You'll just need to trace the wire harness of the old rooftop unit to the controller. It's going to have a 6-pin or 9-pin connector to plug into the controller. If the old unit has a 9-pin connector then you'll just need an adapter # ACCOLKIT. I've attached a short video below where I'll show you the wire harness and controller.
If your old Dometic system had... view full answer...
We do have the Correct Track Trailer Alignment and Lift Kit # RR23QX which is similar to the Lippert LC407131 and will fit on your 2016 Prime Time Crusader Lite 28RL 5th wheel camper. The Lippert system was discontinued. With the Correct Track # RR23QX you are able to raise your suspension either 1-1/4" or 2-1/4". You can also use it to align your axles if they are not square in your frame and causing the tires to wear unevenly. view full answer...
Water heaters are pretty easy to swap out but I wouldn't say it's always a plug and play setup just because you'll sometimes run into tanks where the water line connection points are on the opposite side of the tank. The Atwood GC6AA-10E has it's connections on the right side in a vertical pattern, while the # DMC74FR has it points centered on the middle of the tank in a horizontal pattern. If you have a hard line or PEX you may have to get a soft line hose to go between the water line... view full answer...
The Alpha Systems Patch Kit for SuperFlex RV Roof Membranes # AL37CV is designed for TPO membranes so branding would not matter and you'd be good to go regardless of which brand your roof is. view full answer...
According to my research your 2018 Prime Time Avenger 27BHS should have a 16' wide awning so you'll need one of the following Solera Family Rooms:
- Tan Mesh # LC362219
- Gray # LC362231 view full answer...
Since you have 8000-lb axles, we know that they will use slipper springs and I can narrow your options down to 2 different sized replacement springs for your Sanibel 3500 5th Wheel. In order to choose the right one you'll need to determine the length of the spring. You can measure the length of the spring from the center of the eye on one side to the end of the spring.
If you have 29-1/2" long springs you will need # e46SR . If you have 26-5/8" long springs you will use # e37SR. Keep in... view full answer...
While your 2015 Tracer does fall under the Forest River umbrella it is listed under Prime Time. I do see most models use 3,500lb tandem axles which will use either the Standard # AKEBRK-35 or Self-Adjusting # AKEBRK-35-SA brake kits per axle. You can verify your axles by checking either the information tag on front corner of your camper or by checking to see if the axle tags are still in place on the center of the axles on the back side of the tube.
If you have a different axle capacity... view full answer...
Yes, you can swap out the grease cap of the Dexter Hub part # 8-219-13UC3 to one that has a hole and rubber plug and it would be perfectly compatible with EZ Lube spindles. For that all you'd need is the part # RG04-120 and you'd be set. The only difference between the Dexter EZ lube hubs and non EZ lube hubs is the cap. view full answer...
First you will need to decide if you want the slide toppers in a white or black. Also you will need to ensure you have at least 6" of clearance nest to each side of the slide for the topper to fit properly. If you do not have the minimum clearance next to a slide please let me know which topper doesn't so I can help you find the proper size so you do not have any clearance issues.
White
1. # LCV000163301
2. # LCV000163285
3. # LCV000163307
Black
1. # LCV000168110
2. # LCV000168105
3.... view full answer...
Yes, the Swagman E-Spec Bike Rack # S94FR can be used to carry 2 E-bikes up to 70lbs each behind your 2020 Prime Time Crusader 330MBH 5th wheel camper. I recommend using the Ultra-Fab 2" Motor Home Trailer Hitch Receiver # UF35-946402 to bolt to the 4"x4" bumper on your camper.
A Swagman Bike Cover # S24FR will help keep your bikes clean as large amounts of dirt are attracted to the back of the camper due to the size of it. view full answer...
Go To Results